In the event of a fire alarm the electromagnet is de energised releasing the door.
Magnetic door holders fire alarm systems.
Primary application includes holding and releasing of fire rated doors that are required to provide a barrier for fire and smoke in an emergency or the convenience of door closure by remote control.
The magnetic portion of this device is installed on the wall that meets the open fire door now to tie this whole concept together you will.
En1155 1997 cpd approved floor mounted 24v dc door holder 04390 41.
Both door holders are fitted with an integral manual release button allowing the door to be closed without operating the fire alarm.
Electromagnetic door holders and releasers keep doors open until they are released by fire alarm systems remote smoke detectors or other switching devices.
Wire these holders directly into your fire alarm system.
These door holder releases have a holding force of approximately 25 lbf 111n.
We offer a variety of magnetic door holder and magnetic fire door holder finishes including us28 luma sheen duranodic and gold.
Electromagnetic door holders allow fire detection and alarm systems to control fire doors.
For use with doors that already have a closer these holders keep doors open with an electromagnet.
If the building loses 120 vac power the fire alarm system must switch over to backup batteries calculated to handle all of the devices tied to the system.
When energised the electromagnet holds the door open by magnetically attracting a keeper on the door.
The device holds a door open while energized.
Electromagnetic door holders should be used and.
Both versions are supplied with a door mounting keeper plate.
All are reversible for right or left door swing directions.
Our cal royal magnetic door holders and magnetic fire door holders are ul listed for both the us and canadian market as well as approval from the california department of forestry and fire for the state of california.
Mount the wall plate in an electrical outlet box or use a surface mount box sold separately.
When de energized by a relay controlled by the fire alarm system or other switch the door is released to a closed position checking the spread of smoke and flames.
Depending on your fire alarm installation you may need to install a magnetic door holder at the location of each fire door.
In the event of a power failure they release the door to a closed position to keep the facility secure.
To close fire doors in an emergency and prevent the spread of fire and smoke.
S dc eh series magnetic door holders are designed to hold doors open and release the door by remote switch or fire life safety command center activation.
When activated by a fire alarm the magnet shuts off and releases the door.
Since magnetic door holders perform their intended function with.
The dorgards are great by the way but if the spec is magnetic door retainers they may want them as opposed to dorgards but if its high end property which a flat worth 3 5 mill is id expect a proper fire alarm in tbh a 2 zone panel is cheap enough and will give you the felxibility you need and give you extra income on repairs and servicing.
